Brittle-ductile-brittle deformation during cooling of tonalite (Adamello, Southern Italian Alps)

Late- to post-magmatic deformation in slightly diachronous contiguous intrusions of the north-western Adamello batholith (Southern Alps, Italy) is recorded as, from oldest to youngest: (i) joints, (ii) solid-state ductile shear zones, (iii) faults associated with epidote-K-feldspar veins and (iv) zeolite veins and faults. Structures (ii) to (iv) are localized on the pervasive precursory network of joints (i), which developed during the earliest stages of pluton cooling. High temperature (∼ 500 °C), ductile overprinting of joints produced lineations, defined by aligned biotite and hornblende, on the joint surfaces and highly localized mylonites. The main phase of faulting, producing cataclasites and pseudotachylytes, occurred at ∼ 250 °C and was associated with extensive fluid infiltration. Cataclasites and pseudotachylytes are clustered along different E-W-striking dextral strike-slip fault zones correlated with the activity of the Tonale fault, a major tectonic structure that bounds the Adamello batholith to the north. Ductile deformation and cataclastic/veining episodes occurred at P = 0.25-0.3 GPa during rapid cooling of the batholith to the ambient temperatures (∼ 250 °C) that preceded the exhumation of the batholith. Timing of the sequence of deformation can be constrained by 39Ar-40Ar ages of ∼ 30 Ma on pseudotachylytes and various existing mineral ages. In the whole composite Adamello batholith, multiple magma pulses were intruded over the time span 42-30 Ma and each intrusive body shows the same ductile-to-brittle structural sequence localized on the early joint sets. This deformation sequence of the Adamello might be typical of intrusions undergoing cooling at depths close to the brittle-ductile transition. © 2006 Elsevier B.V. All rights reserved.