The use of plasmas in aerodynamics has become a recent topic of interest. In particular, over the last ten years, plasma actuation has received much attention as a promising active method for airflow control. Flow control consists of manipulating the properties of a generic moving fluid with the aim of achieving a desired change, but flow dynamics in proximity of a solid object is usually considered, being a consistent and significant issue in many engineering applications, such as engine, automobile or airplane design. Plasma control of airflows along surfaces has been the subject of several experimental studies whose aim was to reduce turbulence, to decrease drag, to enhance airfoil lift or to prevent flow detachment. The fast temporal response and the absence of moving parts are the most promising features from which plasma actuators could benefit. Different types of plasma sources are currently studied as good candidates for plasma actuation, but Dielectric Barrier Discharges (DBDs) are usually preferred, being characterized by the presence of an insulating barrier between the electrodes. This allows the generation of a non-thermal plasma at atmospheric pressure and prevents the discharge from collapsing into an arc. Surface Dielectric Barrier Discharges (SDBDs) are particularly suitable for these kinds of applications, since plasma is created by ionizing a thin portion of air nearby the surface of the dielectric barrier and this can effectively influence the local properties of the boundary layer associated to an external flow. This thesis deals with SDBDs in an asymmetric configuration where one electrode is glued into an insulating material and to other one is exposed to air, so that plasma is created in correspondence of just one side of the dielectric barrier. The buried electrode is connected to the ground, whereas a sinusoidal high-voltage is applied to the exposed one. It has been noticed that, when these discharges are operated in quiescent air, an airflow of several metres per second is observed above the dielectric sheet and near the plasma region. This is usually called ionic wind because the main mechanism responsible for its generation is believed to be momentum transfer from the ions drifting in the discharge electric field to the surrounding fluid, by particle-particle collisions. When the electric field imposed by the voltage difference between the electrodes is sufficiently high, plasma is created and electrical charges are transported through the gap and accumulated on the insulating surfaces. This charge accumulation generates an electric field that locally weakens the external one. When the total electric field falls below the threshold necessary for plasma ignition, the discharge extinguishes. If the voltage imposed to the fed electrode is increased, the discharge can be locally initiated again, and that is the reason why a sinusoidal high-voltage supply is adopted instead of a continuous one. Consequently, the presence of the insulating barrier usually leads to a regime where charge is mainly transported in sub-millimetre regions consisting of current filaments with temporal duration limited to a few tens of nanoseconds. These plasma microdischarges are concentrated into two phase intervals of the sinusoidal voltage supply, when the modulus of the applied voltage difference is high enough and is increasing in time. These two phases of plasma activity are often called Backward Stroke (BD) and Forward Stroke (FD), depending if the high-voltage signal is rising from its minimum to its maximum or decreasing from its maximum to its minimum. This thesis is motivated by the fact new studies focusing on plasma properties and dynamics are required in order to get better and better aerodynamic results, to understand which parameters mainly affect the actuator performances and to validate numerical models trying to forecast the aerodynamic effects induced by the discharge. This has brought to a scientific collaboration between the Centre of Excellence PlasmaPrometeo of University of Milano-Bicocca and the Aerodynamics and Wind Tunnel Department of the aerospace company Alenia Aermacchi. During these years I have studied the properties of these discharges by means of electrical and optical diagnostics (mainly Rogowski coils, capacitive probes, a photomultiplier tube and a thermal camera). With some of them a temporal resolution high enough for studying several characteristics of plasma microdischarges has been achieved. This is important because these strokes manifest as series of current and light pulses, lasting tens of nanoseconds and a few nanoseconds respectively. I have first of all carried out a detailed investigation of the properties of these events and of their evolution in space and time in the course of the FD and BD. It has been pointed out that there are several analogies between the BD and FD, but that not all plasma properties are identical for the two semi-cycles, because of the asymmetrical configuration adopted. These investigations let think that light and current signals give insights about different microdischarge properties. Light is presumably ascribable to electrons that excite nitrogen immediately after the passage of the ionizing wave that initiates the microdischarge. In contrast, the current signal is due to the movement of charges into the plasma channel and thus reflects the microdischarge temporal evolution, rather than its formation. In the following experiments I have thus focused mainly on the electrical properties of plasma microdicharges, with the aim of better understanding which plasma characteristics are responsible for the ionic wind generation and properties. Several SDBDs with different geometrical configurations and operating parameters have been considered. It has been found that both the discharge and ionic wind characteristics are mainly affected by the dielectric thickness, whereas other properties of the SDBD are less decisive. These studies are of practical interest because optimizations of SDBD characteristics are still needed for adopting these discharges as plasma actuators for active flow control. In particular, it has been found that at first the speed of the induced wind increases quite linearly with the voltage amplitude, but then this velocity and thus the aerodynamic effects induced by the discharge tend to saturate. This is particularly evident when thin panels are adopted as dielectric barriers. I thus focused on this topic and I found that an asymmetry in the total charge transported by plasma microdischarges during the backward and forward strokes is favourable for obtaining a ionic wind with a greater velocity, and that the velocity saturation at the highest voltages is associated to a change in discharge regime, which is visible first of all because a pattern of plasma filaments appears superimposed to the more homogeneous plasma. I have thus characterized how this regime transition affects the dynamics of the backward and forward strokes. Three groups of microdischarges have been identified, depending on their temporal duration, and results let think that they don't contribute equally to the electric wind generation. These studies pave the way to a better understanding of the discharge peculiarities and ionic wind formation, with the aim of understanding if an intrinsic limit exists in plasma actuator potentialities or if new optimization strategies are possible. Eventually, I proposed to implement the Background Oriented Schlieren (BOS) technique for the visualization and characterization of the airflow induced by the discharge. The potentialities of this technique have been evaluated in relation to the specifics of the available scientific equipment. The technique has then been proved to be able to visualize density changes induced by plasma. A spatial characterization of the air near the discharge was made in stationary wall jet conditions as well as in the transient period following the discharge ignition when a starting vortex is generated.

(2014). Characterization of atmospheric pressure plasmas for aerodynamic applications. (Tesi di dottorato, Università degli Studi di Milano-Bicocca, 2014).

Characterization of atmospheric pressure plasmas for aerodynamic applications

BIGANZOLI, ILARIA
2014

Abstract

The use of plasmas in aerodynamics has become a recent topic of interest. In particular, over the last ten years, plasma actuation has received much attention as a promising active method for airflow control. Flow control consists of manipulating the properties of a generic moving fluid with the aim of achieving a desired change, but flow dynamics in proximity of a solid object is usually considered, being a consistent and significant issue in many engineering applications, such as engine, automobile or airplane design. Plasma control of airflows along surfaces has been the subject of several experimental studies whose aim was to reduce turbulence, to decrease drag, to enhance airfoil lift or to prevent flow detachment. The fast temporal response and the absence of moving parts are the most promising features from which plasma actuators could benefit. Different types of plasma sources are currently studied as good candidates for plasma actuation, but Dielectric Barrier Discharges (DBDs) are usually preferred, being characterized by the presence of an insulating barrier between the electrodes. This allows the generation of a non-thermal plasma at atmospheric pressure and prevents the discharge from collapsing into an arc. Surface Dielectric Barrier Discharges (SDBDs) are particularly suitable for these kinds of applications, since plasma is created by ionizing a thin portion of air nearby the surface of the dielectric barrier and this can effectively influence the local properties of the boundary layer associated to an external flow. This thesis deals with SDBDs in an asymmetric configuration where one electrode is glued into an insulating material and to other one is exposed to air, so that plasma is created in correspondence of just one side of the dielectric barrier. The buried electrode is connected to the ground, whereas a sinusoidal high-voltage is applied to the exposed one. It has been noticed that, when these discharges are operated in quiescent air, an airflow of several metres per second is observed above the dielectric sheet and near the plasma region. This is usually called ionic wind because the main mechanism responsible for its generation is believed to be momentum transfer from the ions drifting in the discharge electric field to the surrounding fluid, by particle-particle collisions. When the electric field imposed by the voltage difference between the electrodes is sufficiently high, plasma is created and electrical charges are transported through the gap and accumulated on the insulating surfaces. This charge accumulation generates an electric field that locally weakens the external one. When the total electric field falls below the threshold necessary for plasma ignition, the discharge extinguishes. If the voltage imposed to the fed electrode is increased, the discharge can be locally initiated again, and that is the reason why a sinusoidal high-voltage supply is adopted instead of a continuous one. Consequently, the presence of the insulating barrier usually leads to a regime where charge is mainly transported in sub-millimetre regions consisting of current filaments with temporal duration limited to a few tens of nanoseconds. These plasma microdischarges are concentrated into two phase intervals of the sinusoidal voltage supply, when the modulus of the applied voltage difference is high enough and is increasing in time. These two phases of plasma activity are often called Backward Stroke (BD) and Forward Stroke (FD), depending if the high-voltage signal is rising from its minimum to its maximum or decreasing from its maximum to its minimum. This thesis is motivated by the fact new studies focusing on plasma properties and dynamics are required in order to get better and better aerodynamic results, to understand which parameters mainly affect the actuator performances and to validate numerical models trying to forecast the aerodynamic effects induced by the discharge. This has brought to a scientific collaboration between the Centre of Excellence PlasmaPrometeo of University of Milano-Bicocca and the Aerodynamics and Wind Tunnel Department of the aerospace company Alenia Aermacchi. During these years I have studied the properties of these discharges by means of electrical and optical diagnostics (mainly Rogowski coils, capacitive probes, a photomultiplier tube and a thermal camera). With some of them a temporal resolution high enough for studying several characteristics of plasma microdischarges has been achieved. This is important because these strokes manifest as series of current and light pulses, lasting tens of nanoseconds and a few nanoseconds respectively. I have first of all carried out a detailed investigation of the properties of these events and of their evolution in space and time in the course of the FD and BD. It has been pointed out that there are several analogies between the BD and FD, but that not all plasma properties are identical for the two semi-cycles, because of the asymmetrical configuration adopted. These investigations let think that light and current signals give insights about different microdischarge properties. Light is presumably ascribable to electrons that excite nitrogen immediately after the passage of the ionizing wave that initiates the microdischarge. In contrast, the current signal is due to the movement of charges into the plasma channel and thus reflects the microdischarge temporal evolution, rather than its formation. In the following experiments I have thus focused mainly on the electrical properties of plasma microdicharges, with the aim of better understanding which plasma characteristics are responsible for the ionic wind generation and properties. Several SDBDs with different geometrical configurations and operating parameters have been considered. It has been found that both the discharge and ionic wind characteristics are mainly affected by the dielectric thickness, whereas other properties of the SDBD are less decisive. These studies are of practical interest because optimizations of SDBD characteristics are still needed for adopting these discharges as plasma actuators for active flow control. In particular, it has been found that at first the speed of the induced wind increases quite linearly with the voltage amplitude, but then this velocity and thus the aerodynamic effects induced by the discharge tend to saturate. This is particularly evident when thin panels are adopted as dielectric barriers. I thus focused on this topic and I found that an asymmetry in the total charge transported by plasma microdischarges during the backward and forward strokes is favourable for obtaining a ionic wind with a greater velocity, and that the velocity saturation at the highest voltages is associated to a change in discharge regime, which is visible first of all because a pattern of plasma filaments appears superimposed to the more homogeneous plasma. I have thus characterized how this regime transition affects the dynamics of the backward and forward strokes. Three groups of microdischarges have been identified, depending on their temporal duration, and results let think that they don't contribute equally to the electric wind generation. These studies pave the way to a better understanding of the discharge peculiarities and ionic wind formation, with the aim of understanding if an intrinsic limit exists in plasma actuator potentialities or if new optimization strategies are possible. Eventually, I proposed to implement the Background Oriented Schlieren (BOS) technique for the visualization and characterization of the airflow induced by the discharge. The potentialities of this technique have been evaluated in relation to the specifics of the available scientific equipment. The technique has then been proved to be able to visualize density changes induced by plasma. A spatial characterization of the air near the discharge was made in stationary wall jet conditions as well as in the transient period following the discharge ignition when a starting vortex is generated.
RICCARDI, CLAUDIA
plasma actuator, surface dielectric barrier discharge, background oriented schlieren
FIS/01 - FISICA SPERIMENTALE
English
25-set-2014
Scuola di dottorato di Scienze
FISICA E ASTRONOMIA - 30R
26
2012/2013
open
(2014). Characterization of atmospheric pressure plasmas for aerodynamic applications. (Tesi di dottorato, Università degli Studi di Milano-Bicocca, 2014).
File in questo prodotto:
File Dimensione Formato  
phd_unimib_065090.pdf

accesso aperto

Tipologia di allegato: Doctoral thesis
Dimensione 11.08 MB
Formato Adobe PDF
11.08 MB Adobe PDF Visualizza/Apri

I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.

Utilizza questo identificativo per citare o creare un link a questo documento: https://hdl.handle.net/10281/53249
Citazioni
  • Scopus ND
  • ???jsp.display-item.citation.isi??? ND
Social impact